moyle90071 moyle90071

Today at 8:45 AM
Business

Answered

Which of the following could explain why a firm is a monopoly?

Option 1: Low production costs.
Option 2: Perfect competition in the market.
Option 3: Barriers to entry.
Option 4: High levels of competition.

Answer :

Other Questions

Milk can be received at 45°F (7°C) under what condition?A) It is thrown out after 2 daysB) It is cooled to 41dF or lower in 4 hoursC) It is immediately cooled t

What is the correct temperature for receiving cold TCS foods?A) 32dF (0dC) or lowerB) 41dF (5dC) or lowerC) 45dF (7dC) or lowerD) 50dF (10dC) or lower

How many inches from the floor should food be served?A) At least 1 inchB) At least 2 inchesC) At least 4 inchesD) At least 6 inches

Find the coordinates of a point P on y-axis which divides the line segment joining points (-2, 3) and (4, 3) in the ratio 1:2.

देरी लेखन करते हुए दोस्तों के साथ पिकनिक मनाने की खुशी का का वर्णन कीजिए

The use of alcohols and it's production

who is the first scientist of India

Please answer the question in the attachment please

If dye penetrant inspection indications are not sharp and clear, the most probable cause is that the part ? 1) is not properly cleaned 2) has a rough surface 3)

The primary purpose of providing suitable bends in fluid and pneumatic metal tubing runs is to . 1) Increase the flow rate of the fluid or gas 2) Reduce the pre

If an aircraft CG is found to be at 24, What does CG stand for? 1) Center of Gravity 2) Coefficient of Lift 3) Control Group 4) Cabin Crew

A particular component is attached to the aircraft structure by the use of an aircraft bolt and a castle tension nut combination. If the cotter pin hole does no

The reheating of a heat treated metal, such as with a welding torch, has little or no effect on a metal's heat treated characteristics? 1) True 2) False

When installing bonded clamps to support metal tubing, What is the recommended procedure to prevent corrosion?

If it is necessary to accurately measure the diameter of a hole approximately 1/4 inch in diameter, the mechanic should use a telescoping gauge and determine th

A bolt with an X inside a triangle on the head is classified as an ? 1) Anchor bolt 2) Carriage bolt 3) Hex bolt 4) T-bolt

Bonded clamps are used for support when installing metal tubing. Unbonded clamps are used for support when installing wiring? 1) True 2) False

Which of the following statements about jet fuel and aviation gasoline is true? 1) Jet fuel is of higher viscosity than aviation gasoline and therefore holds co